SOUTHERN AVIONICS COMPANY
SE Series Installation and Setup
3-1
3 Cable/Wire Selection, Routing and Connection
3.1 Gaining Access to the Power and I/O Terminal
Blocks
Requirements:
1 - 11/32” nut driver (6”) to remove terminal block covers for TB5 and TB6
1 - #2 Phillips head screwdriver (6”) to loosen hardware on TB5 and TB6
1 - 1/4” nut driver (6”) to remove terminal block covers on TB4
1 - #1 Phillips head screwdriver (6”) to loosen hardware on TB4
1 - heavy duty tie wrap, provided in ship kit
The Ship kit is a part of the SE125 and contains the following:
1 - Alignment tool
2 - 7” Cable wraps
1 - 7’ Cable
2 - Conduit Assemblies
3.1.1
Prior to making any wiring connection, remove the four (4) dresser screws holding the lower
Transmitter Drawer in place. The drawer must be removed to allow full access to the system’s
terminal blocks. Method 1 is desired and requires a work bench or stool of suitable height to
support the drawer. Method 2 simply suspends the drawer from the right extended outer slide
using a tie wrap. Refer to drawing Figure 3-1 for a visual explanation.
Warning
: If Method 2 is used, ensure wind loading on the suspended drawer will not
cause damage to the drawer slide, metal, terminal block, or its wiring.