Storing Machine - Page 79
STORING MACHINE
Preparing Engine:
1. Change engine oil and filter while engine is warm.
2. Service air filter if necessary.
3. Clean debris from engine air intake screen.
4. Remove spark plugs. Put 30 mL (1 oz.) of clean
engine oil in cylinders.
5. Install spark plugs, but DO NOT connect spark plug
wires.
6. Crank the engine for approximately five seconds to
allow oil to be distributed.
7. Clean the engine and engine compartment.
8. Remove battery.
9. Clean the battery and battery posts.
NOTE: The stored battery should be recharged
every 90 days.
10.Charge the battery. (See Charging Battery in the
SERVICE - ELECTRICAL section.)
11.Store the battery in a cool, dry place where it will not
freeze.
12.Store the vehicle in a dry, protected place. If vehicle
is stored outside, put a waterproof cover over it.
Removing Machine From Storage
1. Check tire pressure. (See Checking Tire Pressure in
Service - Miscellaneous section.)
2. Fill fuel tank. Check engine oil level.
3. Take machine off of blocks or support stands.
4. Charge battery if necessary. Install battery. (See
Removing and Installing the Battery in the SERVICE-
ELECTRICAL section.)
5. Check spark plug gap. Install and tighten spark plug
to 20 N•m (15 lb-ft).
6. Lubricate all grease points.
7. Check automatic transmission oil level.
8. Run the engine 5 minutes without the mower or any
attachments running to allow oil to be distributed
throughout engine.
9. Be sure all shields and guards are in place.
