38
12 TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
SOLUTION
The machine does
not start when you
press the switch
trigger (1).
There is no electrical contact
between the machine and the
battery.
·
Remove the battery.
·
Check the contact.
·
Re-insert the battery.
The battery is empty.
Charge the battery.
The safety lock button (2) and the
switch trigger (1) are not pressed
at the same time.
·
Press the safety lock (2) on the battery and hold it down.
·
Push the switch trigger (1) to start the machine.
The machine
stops when you
cut.
The grass deflector is not
mounted to the machine.
·
Remove the battery.
·
Attach the grass deflector to the machine.
Heavy cutting line is used.
Use only nylon cutting line with a diameter of 2 mm.
Grass winds around the motor
shaft and the trimmer head.
·
Stop the machine.
·
Remove the battery.
·
Carefully remove the grass from the motor shaft and/or the trimmer head.
The motor is overloaded.
·
Free the trimmer head from the grass. See the section "If grass wraps around the trimmer head or the shaft
housing" in these operating instructions.
·
You can continue using the motor when the load has been removed.
·
As you are cutting, move the trimmer head into and out of the grass you want to cut and do not cut more than 20 cm in
a pass.
The battery or the machine is too
hot.
·
Let the battery cool until its temperature is reduced.
·
Let the machine cool for approx. 10 minutes.
There is no electrical contact
between the machine and the
battery.
·
Remove the battery.
·
Check the contact.
·
Re-insert the battery.
The battery is empty.
Charge the battery.
The line does not
advance.
The line is stuck.
Oil with silicon spray.
There is not enough line on the
spool.
Install a new spool. For this, see the section in these instructions about replacing the line.
The line is worn and too short.
·
Remove the battery.
·
Pull the line while pushing the trimmer head.
The line is wound around the
spool.
Remove the line from the spool and wind it up. For this, see the section in these instructions about replacing the line.
The line keeps
breaking.
The machine is not used properly.
·
Cut with the tip of the line and avoid contact with rocks, walls and other hard objects.
·
Advance the cutting line regularly for full cutting breadth.
Grass winds
around the shaft
housing and the
trimmer head.
High grass is cut too close to the
ground.
·
Cut high grass from top to bottom.
·
Do not cut more than 20 cm in each pass to prevent grass wrapping around.
The line is not
cutting well.
The blade (7) is dull.
·
Sharpen the blade with a file or replace it.
The vibrations are
increasingly
significantly.
The line is worn down on one side
and did not advance when it was
supposed to.
Make sure that the line can move freely on both sides. Move the line to check.
13 DISPOSING OF THE DEVICE
Do not dispose of electric devices with household waste. Dispose of these devices at recycling centres. Contact the relevant authorities or your retailer for information about this.
Separate collection of used products and packaging allows materials to be recycled. The reuse of materials helps to prevent pollution and reduces the demand for raw materials.
Dispose of batteries at the end of their service life and in a manner that respects the environment. The battery contains material that is dangerous to you and to the environment.
Therefore, it must be disposed of separately in a facility that accepts lithium-ion batteries.
14 SPARE PARTS LIST
·
See spare parts catalogue