17
B1-SWM-Op-Guide-v4.pmd 030108-hto
Push in with
thumb and index
fingers.
Section Five : Receiver & Transmitter Setup
5.6.2 Handheld Microphone (SW30-H, SW16-H)
1. Grip the microphone capsule as shown in Figure 5p. Unscrew the top of the microphone (counter-
clockwise direction).
2. Insert a 9-volt battery into the
battery compartment accord-
ing to the correct polarity as
shown in Figure 5p. Note that
inside the microphone body,
and at the bottom of the bat-
tery cavity, the hole for the
positive contact is larger than
the hole for the negative con-
tact. The moment the battery
touches the terminals inside
the battery compartment, the
On/Battery Indicator will flash briefly. This means the polarity is correct. However, if no flash occurs,
this indicates incorrect insertion, or the battery is dead. Please read Section 5.3.2. Transmitter
LED Indicators for a complete understanding of Sabine multifunction LEDs.
3. Replace cap so that the three contact prongs inside the capsule align with the three silver contact
squares inside the mic body. Tighten capsule finger tight.
CAUTION : Do not force. If the alignment is not correct or the battery is not placed correctly, the
capsule will not close.
5.6.2 Beltpack Transmitters (SW30-TX, SW16-TX)
1. Press in on ribbed areas with thumb and index finger and pull up to open hinged battery door.
2. Note the positive and negative markings on the inside of the battery compartment. Place a 9-volt
battery connector-side first into the battery compartment, making sure the polarity is correct.
3. Push in at ribbed areas and close
door.
NOTE when changing batteries during performance: The Sabine Wireless receiver has a two-
stage squelch system that allows you to turn on or off your transmitter while the receiver and sound
system are on—without causing pops or clicks from the Sabine Wireless system.
Power Switch
Power/Battery LED
Figure 5p - Handheld Microphone Battery Replacement
IMPORTANT
Grip here & turn
counterclockwise
Figure 5q - Beltpack Transmitter Battery Replacement
Note battery
polarity
indicators and
place battery
accordingly. Do
not force.
Summary of Contents for TRUE MOBILITY WIRELESS SYSTEM SWM3000
Page 2: ......
