SIDE
B
© 2004 Sabine, Inc.
SW70-T Beltpack Transmitter Quick Setup Guide
Press down firmly with both thumbs on battery
door handle (above Sabine logo) and slide away
from LCD.
2
1
2
SABINE
13301 NW US Highway 441 • Alachua, FL 32615-8544 USA • +USA (386) 418-2000 • +USA (386) 418-2001 fax
[email protected] • www.Sabine.com
®
Important Battery Information
Your Sabine 2.4 GHz beltpack transmitter (SW70-T) comes with two size AA rechargeable NiMH batteries.
For best results, charge the battery for at least 8 hours before using it for the first time. Please note that the
full charging potential of the battery will be achieved after the first 5 charging cycles have been completed.
These rechargeable NiMH batteries are highly resistant to the “memory effect,” which affects some recharge-
able batteries. The included batteries will provide more lifetime charges and longer battery life for each charge
than many rechargeable batteries.
Acceptable Batteries for use with SW70-T Beltpack Transmitters
WARNING! DO NOT USE: Alkaline Rechargeable Batteries
DO NOT SHORT CIRCUIT. MUST BE
RECYCLED OR DISPOSED OF PROP-
ERLY.
Battery Caution
DO NOT BURN OR PUNCTURE BAT-
TERY. DOING SO COULD RELEASE
TOXIC MATERIALS WHICH COULD
CAUSE INJURY.
Alkaline “AA”
Rechargeable
Batteries
Opening Access Compartment
Lift bottom edge of door slightly and continue
pulling door down away from LCD until the door
opens fully (90-degree angle from transmitter
body).
Closing Access Compartment
With both thumbs pressing firmly on door
handle (above Sabine logo), slide door up to-
ward LCD until door lip catches under main
body of transmitter, and bottom of door is flush
with bottom of transmitter body.
1
Swing door down, flush with transmitter body.
Battery door handle
2 “AA” size (14.5x50.5mm,
• NiMH Rechargeable (Sabine part #: SWBAA2)
• Alkaline: NEDA 14A - ANSI 14A - IEC LR14
• Heavy Duty batteries (NOT recommended)
)
PLEASE
CAREFULLY
READ
THE
OPERATING
GUIDE
FOR
COMPLETE
INSTRUCTIONS
.
