550 [MH110]:
•
Insert 1 flat head screw M6x20mm in each hole
without tightening.
• Proceed to tighten the screws.
558 [MH117]:
• Insert 1 flat head screw M6x16mm in the rear
hole and 1 M6x20mm in the front ones.
• Proceed to tighten the screws.
590/695 [MH118]:
• Insert 1 flat head screw M6x25mm in the central
hole and 1 M6x20mm in the rear and front hole.
• Proceed to tighten the screws.
671 [MH109]:
•
Insert 1 flat head screw M6x20mm in the rear
hole and 1 M6x25mm in the central and front
hole.
• Proceed to tighten the screws.
718 [MH109]:
•
Insert 1 flat head screw M6x25mm in each hole
without tightening.
• Proceed to tighten the screws.
Board connection:
• Insert the proper screws for the board from the upper
side.
Check that all screws are inside the bushing before
tightening.
•
Proceed to tighten the screws.
Lithium
grease
[MHW
033]
Front wing screws:
kite foil manual - REV01
2
Match the fuselage [MH112]:
•
Insert 1 socket head screw M6x20mm and 1 washers
6.2x
9.9 x 1mm in each hole without tightening.
Proceed to tighten the screws.
•
Always keep the threaded holes and every connection between
carbon (mast and wings) and aluminum (fuselage) clean and
greased with "lithium grease" [MHW033] to avoid and prevent
oxidation and corrosion due to salt water.
Stabilizers screws [MH107]:
• Insert 1 flat head screw M6x16mm in
each hole without tightening.
• Proceed to tighten the screws.
Check the latest version of this manual
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
