Sabfoil Moses Quick Start Manual Download Page 2

Brass bushing M6 

[MHW026] 

(Only if use M6 

screws)

Washers 

Ø8.2XØ 13.2X1 mm

[MH126]

Always keep the threaded holes and 

every connection between carbon 

(mast and wings) and aluminum 

(fuselage) clean and greased with 

"lithium grease" [MHW033] to avoid 

and prevent oxidation and corrosion 

due to salt water.

 142,00 

 80° 

 80° 

 155,70 

 52,75 

 34,23 

Button head screws and washers 

M6 

(According with board thickness)

SCREWS NOT INCLUDED

         

           STABILIZERS 

SCREWS 

Stabilizer 450/483 [MH108]:

-Insert the flat head screw 

M6x20mm in  the front hole 

without tightening.

-Insert the flat head screw 

M6X16mm in the rear hole without 

tightening.

-Proceed to tighten the screws.

[MHW033]

           

-Insert the two socket head screws M8X40mm code [MH126] to fix the 

fuselage with mast.

-Check that all screws are inside the holes before tightening. Proceed to 

tighten the screws.

[MHW033]

Mast:

Socket head screws 

M8X40mm

SABFOIL provides a standard tuttle of 16mm thickness.

Before complete the final assembly please read instruction carefully

                                        

   

WARNING

1)BE SURE THAT THE TUTTLE HEAD MATCHES PERFECTLY WITH YOUR TUTTLE BOX
2) CHECK THAT THE 2 TUTTLE SCREWS ARE THE CORRECT LENGHT FOR YOUR BOARD
3)CHECK THAT THE THREAD ON THE TWO BRASS BUSHINGS IS IN LINE WITH THE RESPECTIVE 

HOLES BEFORE TRYING TO INSERT THE SCREWS

2

Check the latest version of this manual

  WIND FOIL MANUAL

Match the fuselage [MH112]:

- Insert 1 socket head screw 

M6x20mm and 1 washers

Ø6.2x 9.9 x 1mm in each hole 

without tightening.

- Proceed to tighten the 

screws.

                    

                      

                 

FRONT WINGS SCREWS

873 [MH119]:

-Insert the flat head screws M6X50mm

in front and central holes without tightening.

-Insert the flat head screw M6X45mm 

in the rear hole without tightening.

-Proceed to tighten the screws with the supplied wrench.

790 [MH124]:

-Insert the flat head screws M6x30mm

in the side holes without tightening.

-Insert the flat head screws M6X35mm

in the central hole without tightening.

-Proceed to tighten the screws with the supplied wrench. 

633 [MH114]:

-Insert the flat head screws M6x30mm in the corrisponding 

holes without tightening.

-Proceed to tighten the screws.

Reviews: