Saba DP265X, Instruction Manual, Page: 36 / 48

the first time to allow the system to settle. Do not position next to any heat source e.g.
cooker, boiler or in direct sunlight etc.
Allow at least 10cm of space at the top and 10 cm of space on both sides of the appliance
and between the back of the appliance and the wall for adequate air circulation. The
appliance is not designed for recessed installation (“building in”).
Install on a good firm level surface, and any unevenness of the floor should be corrected
prior to installation, slight unevenness can be overcome by adjusting the front feet.
NOTE : If the appliance is positioned on a carpet, soft floor covering you should readjust the
front feet once the appliance has had time to settle.
USE

This appliance is designed to operate in ambient temperature between 16
o
C and 38
o
C. If these temperatures are exceeded, i.e. colder or warmer, the appliance will not
operate correctly. If the ambient temperatures are exceeded for long periods, the
temperature in the freezer section will rise above -18
o
C and food spoilage may
occur.

Remove all packaging materials from the appliance. Wash the inside of the cabinet
with lukewarm water and bicarbonate of soda (5ml to 0.5 liter of water). Dry the
appliance thoroughly.

When you use the freezer for the first time or after defrosting, set the thermostat
control to the maximum position for at least 2 hours before introducing food to be
stored, and then readjust to the normal position.

If there is a power failure, do not open the door. Frozen food should not be affected if
the failure lasts for less than 12 hours. If the failure is longer, then the food should be
checked and either eaten immediately or cooked and then re-frozen.
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat knob located inside the fridge, towards the
upper right-hand corner. Turn the knob from the STOP (OFF) position towards the higher
numbers for colder temperatures. The knob can be adjusted from setting MIN, MED, MAX.