Installation
Use
time to allow the system to settle. Do not position next to any heat source e.g.
cooker, boiler or in
direct sunlight etc.
A
llow at least 10cm of space at the top and 10 cm of space on both sides of the appliance and
between the back of the appliance and the wall for adequate air circulation. The appliance is not
designed for recessed installation (“building in”).
installation, slight unevenness can be overcome by adjusting the front feet.
NOTE:
once the appliance has had time to settle.
•
This appliance is designed to operate in ambient temperature between 16°C and 43°C. If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly. If the
ambient temperatures are exceeded for long periods, the temperature in the freezer section will
rise above -18°C and food spoilage may occur.
•
Remove all packaging materials from the appliance. Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5ml to 0.5 liter of water). Dry the appliance
thoroughly.
•
maximum position for at least 2 hours before introducing food to be stored, and then readjust to
the normal position.
•
If there is a power failure, do not open the door.
lasts for less than 12 hours. If the failure is longer, then the food should be checked and either
eaten immediately or cooked and then re-frozen.
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat knob located inside the fridge, towards the upper
right-hand corner. Turn the knob from the MIN position towards the higher numbers for colder
temperatures. The knob can be adjusted from setting MIN, MED, MAX.
Higher settings on the knob (MAX) mean lower temperatures (colder) in all compartments of the
appliance.
correct setting of the temperature control knob, depending on your ambient conditions.
Set the thermostat knob to a middle position to achieve -18°C in the freezer compartment.
Please Note:
appliance or re-inserting the plug into the wall outlet. This is to allow the protection device in the
compressor to reset.
If the compressor fails to start correctly remove the plug and wait for 5 minutes before you try again
then the compressor should restart normally.
•
The room temperature
•
How often the door is opened
•
How much food is stored
•
Position of the appliance
When you set the correct temperature, all these factors mentioned above shall be taken into account.
TEMPERATURE INDICATE
In order to help you get the correct adjustment of your device, it is equipped with a temperature
gauge placed in the coldest area.
For the proper storage of food in your refrigerator and in particular in the coldest area, make sure that
“OK” appears in the temperature indicator.
The symbol on the left side indicates the location of the coldest area of your
refrigerator.
.
7
6
GB
GB
