Specifications
GAUGE INFORMATION
Problem
Possible Cause
Solution
Troubleshooting:
Contents:
In The Box
Qty
Clock gauge
Mounting U bracket
Mounting U bracket studs (M4x0.7 thread)
Mounting U bracket nuts
Fitting instructions
1
1
1
2
2
Notes
1
Operating range
8V+ to 18V+
Gauge lighting type
50mm (minimum)
Total depth of gauge
55mm (including bezel)
Mounting hole size (52mm gauges)
52mm
Gauge lighting colours
-gauge not reading
-bad connection
-check wiring for bad connections or wire
gauge directly to a battery to test
-gauge has been dropped
-replace gauge
-no back lighting
-incorrect wiring
-connected to a dimmer
-refer to fitting instructions
-refer to fitting instructions
Part No.
Mounting depth required for gauge
Please note:
If you are having problems with the installation of this product, please do not
contact your retailer or SAAS until you have read
ALL
the troubleshooting notes below.
Page 2/4
Page 3/4
User Functions:
1
Programming button
Programming button length
1 meter
-clock won’t adjust
-incorrect wiring
-refer to fitting instructions
-programming button not
connected or damaged
-connect button or check button for
normal operation with a multimeter
red - green - blue - purple - white - amber - pink -
ice blue - orange - aqua - OFF - cycle mode
For further assistance email: [email protected]
Current draw
0.02A - standby mode (ignition off)
Day Colour
Red
Blue
Green
Amber
Park Lights
OFF
Night Colour
Park Lights
ON
User Functions
Gauge will exit after 5 seconds of no activity.
Ignition
ON
Cycle
Purple
White
Aqua
Ice Blue
Pink
Orange
Off
Red
Blue
Green
Amber
Cycle
Purple
White
Aqua
Ice Blue
Pink
Orange
Off
Note:
Use the remote programming button or the button on the back of the gauge to set the below
functions.
Exit
Hold button until gauge beeps > release
button and press to set colour
Colour
setting
Press Button x1
Press Button x2
Night Brightness
Day Brightness
Park Lights
OFF
Park Lights
ON
1 2 3 4 5
Dark Bright
1 2 3 4 5
Dark Bright
Brightness
setting
Hold button until gauge beeps > release
button and press to set colour
Press Button x3
Clock adjust
setting
Hold button until gauge beeps > release
button and press to set clock
-back light colour is set to off
-refer to user functions
SG4106
Gauge power connector
Gauge link connector
SG5100
SG9101
SG61005
1
Gauge power harness length
Gauge link harness length
1 metre
300mm
10 colour LED with 5 levels of brightness
