24 47 29 653
Saab 9-5 B205, B235, B308
89
M02-:
Route the section of cable harness with
the most cables alongside the car's ordinary
harness towards the engine bay's electrical cen-
tre.
90 Route the section of harness that shall go to the
cabin between the coolant reservoir and the
body. Continue along the bonnet catch cable in
to the bulkhead space.
91
M02-:
Remove the tape and cable tie from the
electrical centre gaiter and thread the harness
through the gaiter into the electrical centre.
92
M02-:
Fasten the wiring harness from the kit to
the car's wiring harness with the edge of the
tape located by the cable tie securing the elec-
trical centre wiring harness to the relay plate,
and position a cable tie at the white marking.
93
M02-:
Connect the harness cable shoe which
has red/grey and red/white cable to fuse FF5.
94
M02-:
Connect the cables to relay position FR5
as follows (the marking on the top in brackets):
Red/white cable to position 84 (1)
Two red/white cables to position 80(3)
Blue cable to position 82 (2)
Brown cable to position 81(5)
95 Fit a grommet on the wiring harness.
96
LHD:
Remove the plug to the left of the bonnet-
catch cable grommet, make a hole in the insula-
tion and push the harness through into the
cabin. The harness should be pushed through
until the marking is level with the grommet hole.
Push the grommet into place and seal with Ter-
oson T242 ( part No. 30 15 781) or equivalent
sealer.
RHD:
Remove the section of insulation matting
where the rubber plug is situated ( this can be
felt as a small bulge). Remove the rubber plug,
make a hole in the insulation and push the har-
ness through into the cabin. The harness should
be pushed through until the marking is level with
the grommet hole. Push the grommet into place
and seal with Teroson T242 ( part No. 30 15 781)
or equivalent sealer.
E980A550
89
91
89
92
96
90
93
94