- 11 -
PART B – AM/FM DIGITAL CLOCK RADIO
B1. POWER FAILURE INDICATOR
When AC power is interrupted (disconnected) for a short period. Both time and
alarm setting will change (unless optional clock timer “NO WORRY” Battery Backup is
installed). After AC power is restored (RECONNECTED) the DIGITAL DISPLAY will blink
to indicate that power was interrupted and you must readjust the TIME and ALARM
settings. (See “NO WORRY” BATTERY BACKUP SYSTEM.) To stop display from blinking,
press HOUR or MINUTE time set button.
B2. RADIO OPERATION
1. Plug the Power Cord into any 120 volt AC household outlet.
2. Slide the FUNCTION SELECTOR to ON.
3. Select AM or FM broadcasts using the BAND switch.
4. Select a station with the TUNING CONTROL and adjust the VOLUME CONTROL to
your preferred listening level.
5. Turn the radio OFF by sliding the FUNCTION SELECTOR to OFF.
B3. SET THE TIME
The digital clock has a 12 hour format. The AM or PM indicator to the left of the
digital display will light when the clock is reading AM or PM time.
Use the HOUR and MINUTE time set buttons to set the AM or PM time you want.
NOTE:
For display of minutes and seconds only, hold down the WAKE push button and,
then, the SLEEP push button, The Hour digit(s) will display the minutes and the Minutes
digit(s) will display the seconds. Release both push buttons and current time will be
displayed.
B4. SET THE WAKE TIME
Select the AM or PM time that you want your radio or alarm to turn on automatically
by following these simple steps:
1. Slide the FUNCTION SELECTOR to OFF.
2. Press and hold the WAKE button. The display changes to Wake time.
3. Use the HOUR and MINUTE buttons to set the display to your desired AM or PM wake
time.
4. Release the WAKE button. The current time is again displayed.
B5. WAKE TO MUSIC OR ALARM
YOUR CHOICE OF:
Wake to Music
1. Select your AM or FM Station as outlined under RADIO OPERATION.
2. Slide the FUNCTION SELECTOR to OFF.
3. Set wake time as outlined under SET THE WAKE TIME.
