5
2.
All slide components require periodic maintenance. Clean components with a
cotton cloth and a non-abrasive soap and water. Avoid harsh chemicals and
disinfectants.
3.
Always read the label instructions on any cleaner carefully before applying it to a
surface.
4.
Inspect the plumbing system for leaks. Freeze/Thaw cycles may cause leaks at
plumbing joints which should be repaired prior to use.
5.
Check all safety labels to insure they have not peeled or been removed. Contact
S.R. Smith Customer Service (800-824-4397) for replacement labels.
6.
The support structure is made from steel, is primed and powder coated with a
high quality acrylic urethane finish. However, corrosion may occur depending on
water chemistry and environmental conditions. Inspect the slide on a semi-
annual basis, sand and repair any surface rust. For touch-up paint (PN # 09-819-
1), contact S.R. Smith Customer Service (800-824-4397).
CAUTION: Because this product is manufactured from Steel, placement on a pool
with a Salt Chlorine Generator will require frequent inspection and maintenance due
to the corrosive nature of these systems with all steel alloys. It is recommended that
all slide components be rinsed daily with fresh water.
APPLICABLE STANDARDS AND CODES
The installation of the VORTEX must comply with all applicable governmental and
building codes.
ASSEMBLY AND INSTALLATION
All S.R. Smith VORTEX slides are inspected prior to shipment from the factory. Proper
assembly and installation is mandatory. Improper assembly and installation voids S.R.
Smith’s warranty and may affect the safety of the user. It is the installer’s responsibility
to ensure that the structural integrity of the concrete pad prior to installation of the slide.
DRAWINGS
All drawings in this Slide Owner’s Manual (Figures 1 through 5) are for illustration
purposes only and are
NOT TO SCALE
.
SUBSEQUENT OWNERS
The Owner’s Manual must remain with the owner of the slide. If the owner changes, the
Owner’s Manual shall be brought to the attention of the new owner.