INSTALLATION MANUAL
T7 DIVING SYSTEM™
8
srsmith.com
If purchased, attach the optional waterfall assembly to the underside of the diving board as follows:
IMPORTANT: To keep the T7 water feature from clogging, ensure water is from a filtered return line from the pool.
A) The center (central) rib on the underside of the diving board is hollow and is capped at the factory. Remove the cap from front of
the center rib exposing the hollow channel.
B) The Board Fall comes from the factory with an 8’ length of 1/2” flex PVC pipe attached. The 8’ length goes thru the board and
attaches with PVC glue to one side of the 1/2” union. The 4” length of flex PVC pipe attaches with PVC glue to the stub-up
and then to the other side of the 1/2” union.
C) Once the water tubing is threaded all the way thru the diving board, from the base side, gently pull the end of the tubing until
the waterfall assembly is pulled gently but snugly against the end of the
center rib.
D) Attach the waterfall unit to the Diving Board by inserting the 4 provided screws thru the pre-drilled holes in the waterfall assem-
bly; hand tighten only (DO NOT USE SCREW GUN), over tightening the screws will cause them to strip inside the board or
break the waterfall housing, and voids the warranty.
STEP 1: INSTALL WATER FEATURE: (OPTIONAL EQUIPMENT)
BOARD FALL CONFIGURATION: (OPTIONAL EQUIPMENT)
1. BOARD FALL: kit consists of Edgewater, Mounting Hardware (4 screws), 8’ & 4” of 1/2” Flex PVC Pipe, 1-Union
IMPORTANT: The gel coat surface of the T7 Diving System is similar to a high quality marine finish; it is long lasting, strong and beautiful
but will scratch if mishandled.
Do not place unprotected parts on the ground. Do not slide or pull unprotected parts along any surface. Be careful unpacking parts
and with tools during assembly.
A
B
C
T7 DIVING SYSTEM
INSTALLATION INSTRUCTIONS
