66” Sentry Lifeguard Chair Instruction
22
I
NSTALLING THE
66”
S
ENTRY
L
IFEGUARD
C
HAIR
Warning:
Chair required to be anchored to deck when using umbrella.
Warning:
Do
not lift 66” Sentry chair alone
. Get assistance from one or two others.
Recommended Anchor:
We recommend anchoring with 316L stainless steel 3/8”
-3 ¾
” long wedge
anchors. Sentry 66” Anchoring kit includes four (4) of these anchors
with their washers and nuts.
S.R.
Smith Part Number 13-505.
C
ONCRETE
W
EDGE
A
NCHOR
M
OUNTING
I
NSTRUCTIONS
1.
Place the assembled lifeguard chair on the deck relative to the pool wall.
2.
With the lifeguard chair in its proper location, center punch or otherwise mark
through the mounting holes in the base plates so that a visible mark is apparent on
the concrete.
3.
To protect the lifeguard chair from damage, move it aside before drilling the holes
into the concrete deck.
4.
Drill the holes to the required depth
(min. 2”)
using a hammer drill and a concrete
drill bit. Use tape or a marking on the drill bit to ensure that the hole is drilled to
the required depth. Keep the drill straight and perpendicular to the deck surface
while drilling in order to maintain proper holding strength of the concrete wedge
anchors.
5.
Clear the newly drilled holes of all debris.
6.
Move the lifeguard chair back into position over the holes in the concrete deck.
Fasten the nylon washer, flat washer, and nut so the top of the nut lies flush with
the top of the wedge anchor.
7.
Drive the assembled concrete wedge anchors though the
slide’s
mounting plate
holes until the nylon washer is flush with the base plate as shown in Figure A.
8.
Expand concrete wedge anchor by tightening the nut 3 to 5 turns.
9.
When anchor is set, remove the hex nut and install a lock washer.
10.
Retighten the hex nut to a torque of 25 ft.-lbs. See Figure B for the final assembly.
W
HEEL
-A
WAY
K
IT
I
NSTRUCTIONS
Refer to the instructions (
06-192
) included with the wheel-
away kit or online at srsmith.com.
Figure B
Figure A
⚠
WARNING
⚠
Use caution when tipping
lifeguard chair back to move.
Assembled chair weighs 200 lbs.
Ask for help.
