19
MANUFACTURER’S PLACEMENT INSTRUCTIONS
PROPER ASSEMBLY, INSTALLATION, USE, AND SUPERVISION ARE ESSENTIAL FOR PROPER
OPERATION AND TO REDUCE THE RISK OF SERIOUS INJURY.
1. The critical dimensions for placement of the Rogue 2 are as shown in FIGURE O and FIGURE P.
A. The slide exit runway surface shall not exceed 20” (0.508 M) above the water surface and not
less than 8” (0.203 M) above the deck/coping surface (see FIGURE O)
B. The slide shall be positioned so that all water flowing off the runway exit drops into the pool.
C. The minimum depth of water below the exit lip of the slide shall be 3’ (0.914 M) and increases
to 4’-6” (1.371 M) at Pt. A which is a distance of 4’-6” (1.371 M) from the exit lip of the slide.
(See FIGURE O).
D.
A minimum depth of 4’-6” (1.371 M) shall be maintained at a distance of 9’ (2.743 M) along
the extended centerline of the slide from Pt.A. (See FIGURE O)
.
2.
A minimum clearance area in front of the slide shall be maintained at all
times as follows:
A. A minimum clearance area in front of the slide shall be maintained
away from the coping, another slide, a diving board or a rope and
float line. (See FIGURE P). The minimum clearance distance on
either side of the extended centerline of the slide runway shall not
be less than 3’-6” (1.067 M) at a point no less than 2’-6” (0.762 M)
from the exit of the slide and extending a distance of 13’-6” (1.445
M) in front of the slide. (See FIGURE P)
B. The minimum clearance area in front of a properly installed diving
board on an inground swimming pool is a minimum distance of 3’-
6” (1.067 M) on either side of the board’s centerline as shown in FIGURE Q. Pt.C
extends a minimum distance of “C” from the tip end of the board as shown in FIGURE Q.
The width distance “W” on either side of Pt.C is given in TABLE 1 and shown in FIGURE Q.
FIGURE O
FIGURE P
DECK/COPING SURFACE
3' MIN.
EXIT
RUNWAY SURFACE
PLUMBLINE
20" MAX.
WATER LEVEL
ENTRANCE
Pt.A
13'-6" MIN.
9' MIN.
4'-6"
4'-6" MIN.
4'-6" MIN.