Conveyor Bed Assembly:
1. Remove (4x) Hex-Head Bolts from RC21-LK carton.
2. Place the Conveyor Drive Assembly on the covered floor (See
Figure 1
).
3. Butt the Conveyor Take-Up Assembly to the Drive Assembly. Be sure that the
groove on each roller drum is on the same side of the bed.
4. Bolt the bed assembly together using (4x) Hex-Head Bolts.
Figure 1
5. Insert the Tabs on the Caster Assembly into the slots on the Leg Cross Brace, then
squeeze the Cross Brace to hold the Caster in place (See
Figure 2
).
6. Slide the Leg over the end of the Leg Cross Brace seating the slot in the Leg to
capture the Tab on the Caster.
7. Align the thru-holes with the insert nuts and install the Hex-Head Bolts.
8. Repeat for the four Caster Assemblies, completing the two Leg Assemblies (See
Figure 2
).
Summary of Contents for RCJ21-3500
Page 9: ...Figure 8 ...