Page 15
ADJUSTMENTS
ASSEMBLY
WARNING:
Before connecting saw to power source, make sure the
saw blade or blade guard will not hit the table extensions
or work clamp when cutting 35
°
to 45
°
angles.
WORK CLAMP (Optional)
Whether using a C-Clamp or the optional work clamp, part
number 982021-001, available for your saw, they provide a
means of clamping the work to the fence or table. Clamp-
ing secures the work and prevents the workpiece from
creeping toward the saw blade. This is very helpful when
cutting miters.
WARNING:
When using any clamp with the stop block, install the
clamp on the same side as the stop block. This will
eliminate the possibility of trapping the workpiece, resulting
in the saw blade and workpiece kicking up. Failure to
heed this warning can result in serious personal injury.
NOTE: Many of the illustrations in this manual show only
portions of your miter saw. This is intentional so that we
can clearly show points being made in the illustrations.
Never operate your saw without all guards securely in
place and in good operating condition.
PIVOT ADJUSTMENTS
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
TRAVEL PIVOT ADJUSTMENT
■
The saw arm should rise completely to the up position
by itself.
■
If the saw arm does not raise by itself or if there is play in
the pivot joints, have saw repaired at your nearest RYOBI
AUTHORIZED SERVICE CENTER.
Your Ryobi miter saw has been adjusted at the factory for
making very accurate cuts. However, some of the compo-
nents might have been jarred out of alignment during ship-
ping. Also, over a period of time, readjustment will probably
become necessary due to wear. After unpacking your saw,
check the following adjustments before you begin using
saw. Make any readjustments that are necessary and peri-
odically check the parts alignment to make sure that your
saw is cutting accurately.
WARNING:
Your saw should never be connected to power supply
when you are assembling parts, making adjustments,
installing or removing blades, or when not in use. Discon-
necting your saw will prevent accidental starting that
could cause serious injury.
