background image

STARTING/STOPPING 

INSTRUCTIONS

These instructions replace the starting and stopping instructions in your opera-
tor’s manual and quick reference guide. 

A

Fig. 1

A

Fig. 2

A - Engine switch / fuel valve / choke lever 

(interrupteur du moteur  

/  

robinet de 

carburant / levier d’étrangleur, interruptor del 

motor/válvula de combustible/palanca del 

anegador)

B - START (DÉMARRAGE, ARRANQUE)

C - RUN (MARCHE, MARCHA)

D - OFF (ARRET, APAGADO)

Run switch (interrupteur de marche, 

interruptor de encendido)

A

B

C

D

STARTING THE ENGINE

See Figures 1 - 2.

NOTICE

:

On a level surface with the engine 

off, check the lubricant level before 

each use of the generator. 

NOTE

:  If location of generator is not 

level, the unit may not start or may shut 

down during operation.

 

Unplug all loads from the generator.

 

Verify the run switch is in the 

ON 

position.

 

Move the engine switch/fuel valve/

choke lever to the 

START

 position.

 

NOTE

: If engine is warm or the 

temperature  is  above  50˚F,  move 

the engine switch/fuel valve/choke 

lever to the 

RUN 

position.

  Pull the recoil starting grip until the 

engine runs.

 

NOTE: 

Do not allow the grip to snap 

back after starting return it gently to 

its original place.

 

Allow the engine to run for 15–30 

seconds, then move the engine 

switch/fuel valve/choke lever to the 

RUN

 position.

RY903600

STOPPING THE ENGINE

See Figure 3.

To stop the engine under normal 

operating conditions:

 

Remove any load from the generator.

 

Move the engine switch/fuel valve/

choke lever to the 

OFF 

position.

To stop the unit quickly in an emer-
gency:

 

Place the run switch in the 

OFF 

position.

WARNING:

While operating and storing, keep 

at least 3 feet of clearance on all 

sides of this product, including 

overhead.  Allow a minimum of 30 

minutes of “cool down” time before 

storage. Heat created by muffler 

and exhaust gases could be hot 

enough to cause serious burns 

and/or ignite combustible objects. 

TECHTRONIC INDUSTRIES  

POWER EQUIPMENT

1428 Pearman Dairy Road 

Anderson, SC 29625, USA

Phone 1-800-860-4050

www.ryobitools.com

991000815
11-20-15 (REV:01)

A - Recoil starter grip (poignée de démarreur à 

rappel, mango del arrancador retráctil)

E

Reviews: