Page 6
■
To reduce the risk of damage to charger body and
cord, pull by charger plug rather than cord when
disconnecting charger.
Following this rule will reduce
the risk of serious personal injury.
■
Make sure cord is located to that it will not be stepped
on, tripped over, or otherwise subjected to damage
or stress.
Following this rule will reduce the risk of
serious personal injury.
■
An extension cord should not be used unless
absolutely necessary.
Use of improper extension cord
could result in a risk of fire and electric shock. If extension
cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. That extension cord is properly wired and in good
electrical condition; and
c. That wire size is large enough for AC ampere rating
of charger as specified below:
Cord Length (Feet)
25´
50´
100´
Cord Size (AWG)
16
16
16
Note:
AWG = American Wire Gage
■
Do not operate charger with a damaged cord or plug.
If damaged, have replaced immediately by a qualified
serviceman.
Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
■
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way;
take it to a qualified serviceman.
Following this rule
will reduce the risk of electric shock, fire, or serious
personal injury.
■
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
■
To reduce the risk of electric shock, unplug charger
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this
risk.
Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
■
Do not use charger outdoors.
Following this rule will reduce
the risk of electric shock, fire, or serious personal injury.
■
Disconnect charger from power supply when not in
use.
Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
WARNING:
RISK OF ELECTRIC SHOCK. DO NOT TOUCH
UNINSULATED PORTION OF OUTPUT CONNECTOR
OR UNINSULATED BATTERY TERMINAL.
■
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan someone this tool, loan them these
instructions also.
Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
WARNING:
Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter
out microscopic
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER
