WARNING:
This procedure sheet is not a substitute for reading the operator’s manual. To reduce the risk of injury, the
user must read and understand the operator’s manual before using the product.
TO START A COLD ENGINE:
1
50:1 Ratio = Mix 20 mL of synthetic 2-stroke oil per litre of petrol. Ensure the fuel is fresh and is correctly
mixed before pouring into the fuel tank.
2
Slowly press the primer bulb 10 times or until the fuel appears.
3
Set the choke lever to “full” choke position.
4
Hold down the throttle lock, and then squeeze the throttle trigger.
5
Using manual operation:
Pull the starter grip and rope (4x maximum) until the engine attempts to start.
or
Using ONE+ EASYSTART Module:
Set the ONE+ EASYSTART Module to
, insert into the starter housing, and then press the ONE+
EASYSTART’s power button until the engine attempts to start
(4 seconds maximum).
6
Set the choke lever to “half” choke position.
Using manual operation:
Pull the starter grip and rope (6x maximum) until the engine starts.
or
Using ONE+ EASYSTART Module:
Set the ONE+ EASYSTART Module to
, insert into the starter housing, and then press the ONE+
EASYSTART’s power button until the engine starts
(4 seconds maximum).
NOTE:
If the engine does not start, repeat the procedure from step 3 until the engine starts.
8
Allow the engine to warm for 10 seconds. Set the choke lever to “run” position.
TO START A WARM ENGINE:
Slowly press the primer bulb 10 times or until the fuel appears.
2
Set the choke lever to “run” position.
3
Hold down the throttle lock and then squeeze the throttle trigger.
4
Pull the starter grip and rope until the engine runs. Do not pull the starter grip more than six times.
or
Using ONE+ EASYSTART Module:
Set the ONE+ EASYSTART Module to
, insert into the starter housing, and then press the ONE+
EASYSTART’s power button
(4 seconds maximum).
TO STOP THE PRODUCT:
Push the on/off switch to the “off” position.
Quick Start Guide
RBC254SESO / RPP254JO / RLT254CDSO / RLT254SDSO
9
1
7
