3
ENGLISH
Do not depress throttle trigger while starting.
Pla
ce the en
gine switch to the “
on
” (
I
) position
PRIME - press the primer bulb 10 times slowly
SET
the chok
e lev
er to the “
START
” position
PULL
the starter rope with a quick firm and consistent upward motion
until the
engine starts
.
Note:
If difficulties with starting are experienced (this may occur in colder
conditions) refer to troubleshooting section in this manual.
Allow engine to warm up for 5-20 seconds.
Squeeze the throttle trigger to run.
Note:
Squeezing the throttle trigger releases the start lever to the
RUN
position.
To stop the unit: Place the engine switch to the “
O
” position
The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL
SIGNAL
MEANING
DANGER:
Indicates an imminently hazardous situation, which, if not avoided, will result in
death or serious injury.
WARNING:
Indicates a potentially hazardous situation, which, if not avoided, could result in
death or serious injury.
CAUTION:
Indicates a potentially hazardous situation, which, if not avoided, may result in
minor or moderate injury.
CAUTION:
(Without Safety Alert Symbol) Indicates a situation that may result in property
damage.
SYMBOLS
10
10
SERVICE
Servicing requires extreme care and knowledge and should be
performed only by a qualified service technician. For service we
suggest you return the product to your nearest
AUTHORISED
SERVICE CENTRE
for repair. When servicing, use only identical
replacement parts.
WARNING:
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator’s manual. If you
do not understand the warnings and instructions in the
operator’s manual, do not use this product. Call Ryobi
customer service for assistance.
WARNING:
The operation of any power tool can result in foreign
objects being thrown into your eyes, which can result
in severe eye damage. Before beginning power tool
operation, always wear safety goggles or safety glasses
with side shields and, when needed, a full face shield.
We recommend Wide Vision Safety Mask for use over
eyeglasses or standard safety glasses with side shields.
Always use eye protection which is marked to comply
with standards.
SAVE THESE INSTRUCTIONS
10
10
10
10
10
10
RLT430CES manual(TTIA).indd Sec2:3
RLT430CES manual(TTIA).indd Sec2:3
09-9-23 5:18
09-9-23 5:18