Ryobi RLT36S, Original Instructions Manual, Page: 10 / 12

9
English (Original Instructions)
Problem Possible cause Solution
String will not advance when using the
auto-feed head.
String is welded to itself. Lubricate with silicone spray.
Not enough string on spool.
Install string. Refer to "String
Replacement" earlier in this manual.
String is worn too short.
Pull string while the pressing line release
button.
String is tangled on spool.
Remove string from the spool and
rewind. Refer to "String Replacement"
earlier in this manual.
Grass wraps around shaft housing and
cutting head.
Cutting tall grass at ground level.
Cut tall grass from the top down to
prevent wrapping.
Motor fails to start when switch trigger is
depressed.
Battery is not secure.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Battery is not charged.
Charge the battery pack according to the
instructions included with your model.
Shaft not connected completely.
Make sure the lower curve shaft is fully
seated and secured in the shaft coupling
on the upper shaft.
TROUBLESHOOTING
20120904v1