8
English (Original Instructions)
STARTING THE PRODUCT (FIG. 4-5)
Starting the product differs depending on whether the
engine is cold or warm. Refer to the label on the air filter
cover.
TO START A COLD ENGINE
Follow these steps to start a cold engine.
1.
Lay the product on a flat, bare surface.
2. Ensure the engine switch is in the I (ON) position (item
15).
3. Push the primer bulb (item 18) approximately 10 times.
4. Set the choke lever to Full choke position (item 20).
5. Hold down the throttle lock out button (item 16) and
squeeze the throttle trigger (item 17).
6.
Pull the starter grip (item 19) with a quick firm and
consistent upward motion (No more than 4x).
7. Set the choke lever to Run position (item 21).
8. Hold down the throttle the lock-off button and squeeze
the throttle trigger.
9.
Pull the starter grip with a quick firm and consistent
upward motion until the engine starts (No more than
6x).
Note:
If engine does not start, return to step 4 and repeat
the steps.
Note:
When the engine starts, let it run for 30 seconds
prior to operation.
TO START A WARM ENGINE
Follow these steps to start a warm engine.
1.
Lay the product on a flat, bare surface.
2. Ensure the engine switch is in the I (ON) position (item
15).
3. Ensure the choke lever is set to position B (Choke
Open).
4. Hold down the throttle lock out button (item 16) and
squeeze the throttle trigger (item 17).
5.
Pull the starter grip with a quick firm and consistent
upward motion until the engine starts (No more than
6x).
Note:
If engine does not start, return to step 4 on the "TO
START A COLD ENGINE" and repeat the steps.
STOPPING THE PRODUCT
Release the throttle trigger.
Hold down the engine switch to the O (OFF) position
until the engine comes to a complete stop.
OPERATING THE TRIMMER (FIG. 6)
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged
periods, ensure you take regular breaks.
Follow these steps to operate the curved shaft trimmer.
Start the trimmer.
Hold the trimmer at waist level with your right hand
on the trigger handle and your left hand on the front
handle.
Place the product on the right side of your body with
the engine behind and away from your body.
Trim grass and weeds with the line parallel to the
ground.
TO ADVANCE THE CUTTING LINE
Follow these steps to advance the cutting line.
Start the trimmer.
Tap the bump knob lightly on the ground while the
motor is running. The line will only advance with the
engine at full throttle. Do not hold the bump knob on
the ground.
Note:
The blade on the safety guard will cut the line to
the proper length.
Note:
To help prevent line tangle, tap only once to
lengthen the line. If additional line is required, wait a
few seconds before retapping the bump knob. Do not
allow the line to wear too short. Keep the cutting line at
full length.
MAINTENANCE
MAINTENANCE
WARNING
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING
Always wear safety goggles or safety glasses with side
shields during tool operation. If operation is dusty, also
wear a dust mask.