Safety
3
■
A coasting blade can cause injury while it continues
to spin after the motor is stopped or throttle trigger
released. Maintain proper control until the blade has
completely stopped rotating.
■
It has been reported that vibrations from hand-held
tools may contribute to a condition called Raynaud’s
Syndrome in certain individuals. Identify safety
measures to protect yourself based on an estimation of
exposure in the actual conditions of use, taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time. Limit the amount of
exposure per day.
MAINTENANCE
■
Use only manufacturer’s recommended replacement
parts and accessories.
■
After each use, clean with a soft dry cloth.
■
Check all nuts, bolts and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorized service
centre.
■
When not in use, the product should be stored in a cool
dry place and locked up out of the reach of children. Do
not store outdoors.
Inspection after dropping or other impacts
Thoroughly inspect the product and identify any affections
or damage with it. Any part that is damaged should be
properly repaired or replaced by an authorized service
centre.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps
or tape. Do not transport batteries that are cracked or
leaking. Check with the forwarding company for further
advice.
INTENDED USE
The product is intended for edging along sidewalks,
driveway, flower beds, and similar areas.
The product is not allowed to be used for cutting or
chopping hedges, shrubs, bushes, flowers and compost.
OVERLOAD PROTECTION
Ryobi 36 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximise battery life. If
the tool stops during use, the following may be the causes:
■
The maximum current draw of the battery has been
exceeded, causing it to automatically stop powering the
tool. Release the trigger to reset the tool and pull the
trigger to resume operation.
■
Excessive temperatures will cause the battery to stop
powering the tool. Feel the battery pack; if it is too
warm, allow it to cool down.
RESIDUAL RISKS
Even with the intended use of the appliance, there is
other risk which cannot be prevented. The following list of
potential hazards should be read and understood.
■
Contact with the blade could result in serious personal
injury.
FEATURES
KNOW YOUR PRODUCT
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
EDGER WHEEL
The edger wheel allows for more stable cutting performance
while edging.
DEPTH ADJUSTMENT LEVER
The depth adjustment lever allows user to control depth
of cut.
ADJUSTA BLE FRONT HANDLE
The front handle assembly can be adjusted for ease of
operation and to help prevent loss of control, and can be
positioned above or below the coupler.
HANDLE OVERMOLD
Handle overmold provides added user comfort.
LOCK-OUT
The lock-out prevents accidental starting.
VARIABLE SPEED SWITCH TRIGGER
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
ASSEMBLY
UNPACKING
This product requires assembly.
■
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included.
