background image

3

 

if the product starts to vibrate abnormally 

(inspect immediately)

 

Immediately turn off the product and 

remove the battery pack in the event of 

accident or breakdown. Do not operate 

the product again until it has been fully 

checked by an authorised service centre.

BLOWER SAFETY WARNINGS

 

Wear a face filter mask in dusty conditions 

to reduce the risk of injury associated with 

the inhalation of dust.

 

Slightly dampen surfaces in dusty 

conditions.

 

Do not point the blower nozzle in the 

direction of people or pets.

 

Never place objects inside the blower 

tubes.

 

Do not operate the product near open 

windows.

 

Use the full blower nozzle extension so that 

the air stream can work close to the ground 

and perform effectively.

 

Do not place the product on top of or near 

loose debris. Debris can be sucked into the 

intake vent, resulting in possible damage 

to the product.

ADDITIONAL BATTERY SAFETY 

WARNINGS

 

 WARNING

To  reduce  the  risk  of  fire,  personal  injury, 

and product damage due to a short circuit, 

never immerse the product, battery pack or 

charger in fluid or allow fluid to flow inside 

them. Corrosive or conductive fluids, such 

as seawater, certain industrial chemicals, 

and bleach or bleach-containing products, 

etc., can cause a short circuit.

TRANSPORTATION AND STORAGE

 

Stop the product, remove the battery pack, 

and allow it to cool down before storing or 

transporting.

 

Clean all foreign materials from the product. 

Store the product in a cool, dry, and well-

ventilated place that is inaccessible 

to children. Keep the product away 

from corrosive agents, such as garden 

chemicals and de-icing salts. Do not store 

the product outdoors.

 

For transportation in vehicles, secure the 

product against movement or falling to 

prevent injury to persons or damage to the 

product.

TRANSPORTING LITHIUM BATTERIES

Transport the battery in accordance with local 

and national provisions and regulations.
Follow all special requirements on packaging 

and labelling when transporting batteries by a 

third party. Ensure that no batteries can come 

in contact with other batteries or conductive 

materials while in transport by protecting 

exposed connectors with insulating, non-

conductive caps or tape. Do not transport 

batteries that are cracked or leaking. Check 

with the forwarding company for further 

advice.

MAINTENANCE

 

 WARNING

Use only original manufacturer’s 

replacement parts, accessories, and 

attachments. Failure to do so can cause 

possible injury, can contribute to poor 

performance, and may void the warranty.

 

 WARNING

Servicing requires extreme care and 

knowledge and should be performed only 

by a qualified service technician. Have the 

product serviced by an authorised service 

centre. When servicing, use only original 

replacement parts.

 

Do not make adjustments and repairs not 

described in this manual. For other repairs, 

contact an authorised service agent.

 

After each use, clean the product with a 

soft, dry cloth.

 

Check all nuts, bolts, and screws at 

frequent intervals for proper tightness to 

ensure that the product is in safe working 

condition. Any part that is damaged should 

be properly repaired or replaced by an 

authorised service centre.

 

Bring the product to an authorised service 

centre to replace damaged or unreadable 

labels.

Summary of Contents for RBL3600

















Reviews: