4
Original Instructions
be controlled with a switch is dangerous
and must be repaired.
■
Keep a minimum distance of 30 cm when
cleaning vehicles. The high pressure jet
may damage or burst vehicle tires and/or
tire valves.
■
Use a garden hose with a maximum length
of 15 m and compatible with 12 mm hose
connector.
■
Before each use, ensure that the accessory
is securely attached to the trigger gun.
OVERLOAD PROTECTION
The product has an overload protection device
that is activated when overheating or when a
current spike occurs, automatically shutting
down the power within the product. To resume
operation, disconnect the product from the
power supply, wait for about 15 minutes, and
reconnect the product to the power supply.
TRANSPORTATION AND STORAGE
CAUTION!
Mind the weight of the product
when selecting the storage location and during
transportation to prevent accidents or injuries.
■
Stop the product, disconnect from the power
supply, and allow the product to cool down.
Disconnect the product from the water
supply before storing or transporting. Never
place the product in any position other than
upright.
■
Clean all foreign materials from the
product. Storing the product in an area
with temperature below 0°C will damage
the product Store it in a cool, dry, and
well-ventilated place that is inaccessible
to children. Keep the product away from
corrosive agents such as garden chemicals
and de-icing salts. Store the product indoors
only.
■
Remove water from all hoses and the pump,
and empty the detergent tank before storing
the product.
■
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
■
Store the product indoor only. Storing the
product in an area with temperature below
0°C will damage the product.
MAINTENANCE
■
Use only original manufacturer’s
replacement parts, accessories, and
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■
Servicing requires extreme care and
knowledge and should be performed only
by a qualified service technician. Have the
product serviced by an authorised service
centre only.
■
Turn off the product, disconnect from the
power supply, and allow the product to cool
down. Make sure that all moving parts have
come to a complete stop:
●
before cleaning the product
●
before maintaining the product
●
before replacing spare parts
■
You may make adjustments or repairs
described in this manual. For other repairs,
have the product serviced by an authorised
service centre only.
■
Regularly inspect and maintain the product
for safe operation. RYOBI recommends
inspecting the product every 6 months.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.
SAFETY DEVICES
■
On/off switch
–
The on/off switch prevents unintentional
operation of the product.
■
Trigger handle lock
–
The trigger handle lock locks the trigger
and prevents unintentional opening of
the high-pressure jet.
■
Pressure switch
–
The overflow valve prevents the
permissible working pressure from being
exceeded. If the lever on the trigger gun
is released, the pressure switch turns
off the pump and the high-pressure jet
stops. If the lever is pulled, the pump
turns on again.
■
Overload protection
–
A thermal sensor protects the product
from overloading. The product will
