Ryobi R18NL15, Original Instructions Manual

Page: 3 / 18

Safety
3
INTENDED USE
Safety, performance, and dependability have been given
top priority in the design of your nailer.
The product is intended to drive nails in soft materials such
as wood. It can be used in the following:
■
Finish and trim (interior and exterior)
■
Door and window casing
■
Door jambs
■
Baseboard
■
Crown molding
■
Cabinetry
■
Cap and shoe molding
■
Molding
■
Wooden staircases
■
Door and window trim
■
Chair rail
■
Brickmold
■
Hardwood flooring
■
Paneling
■
Furniture
The product is not suitable for fixing electric cables.
The product is intended to operate in full sequential
actuation mode only:
■
In full sequential actuation mode, the nailer will fire a
nail each time when the trigger switch is squeezed after
safety contact tip has been pushed into the workpiece.
Both safety contact tip and trigger switch must be
released and activated again at the same sequence to
fire a second nail.
Do not use this product in any way other than those stated
for intended use.
NOTE: Some timbers (such as very dry hardwood) may
require shorter nails to fully drive in.
GENERAL POWER TOOL SAFETY WARNINGS
WARNING
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term “power tool’’ in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
1) WORK AREA SAFETY
■
Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
■
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
■
Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
2) ELECTRICAL SAFETY
■
Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
■
Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
■
Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
■
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges
or moving parts. Damaged or entangled cords
increase the risk of electric shock.
■
When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk of
electric shock.
■
If operating a power tool in a damp location
is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD reduces
the risk of electric shock.
3) PERSONAL SAFETY
■
Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention while operating power tools
may result in serious personal injury.
■
Use personal protective equipment. Always
wear eye protection. Protective equipment such
as dust mask, non-skid safety shoes, hard hat or
hearing protection used for appropriate conditions
will reduce personal injuries.
■
Prevent unintentional starting. Ensure the
switch is in the off-position before connecting
to power source and/or battery pack, picking up
or carrying the tool. Carrying power tools with your
finger on the switch or energising power tools that