Ryobi HP62, Operator'S Manual

Page: 9 / 18

Page 9
5
1
0
3
Fig. 4
WARNING:
If any parts are missing, do not operate tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
SWITCH
See Figure 4.
Your drill starts and stops by depressing and releasing the
switch trigger.
Your drill has a two-speed feature in the switch. Depress
the switch trigger halfway for driving screws at low speed.
Depress the switch trigger all the way for normal drilling.
Release the switch trigger to turn drill
OFF .
SWITCH LOCK
See Figure 4.
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use. To lock the switch trigger, place the direction
of rotation selector in the center position.
TO INSTALL BATTERY PACK MODEL HP722
■
Place the direction of rotation selector in center posi-
tion.
See Figure 4.
■
Place the battery pack in your drill. Align raised rib on bat-
tery pack with groove in drill's battery port.
See Figure 5.
■
Make sure the latches on each side of your battery pack
snap in place and that battery pack is secured in drill
before beginning operation.
TO REMOVE BATTERY PACK MODEL HP722
■
Place the direction of rotation selector in center posi-
tion.
See Figure 4.
■
Locate latches on side of battery pack and depress both
sides to release battery pack from your drill.
See Figure 5.
■
Remove battery pack from your drill.
DIRECTION
OF ROTATION SELECTOR
SWITCH
TRIGGER
CENTER
POSITION (LOCK)
IMPORTANT INFORMATION FOR
RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries be-
come hot. You should let the batteries cool down for approxi-
mately 30 minutes before attempting to recharge.
Note: This situation occurs when continuous use of your drill-
driver causes the batteries to become hot. It does not occur
under normal circumstances. Refer to
"Charging Your Drill-
Driver" for normal recharging of batteries. If the charger does
not charge your batteries under normal circumstances, return
both the drill-driver and charger to your nearest AUTHO-
RIZED SERVICE CENTER for electrical check.
For more information on the battery recycling call
1-800-8 BATTERY.
Fig. 5
CAUTION:
When placing battery pack in your drill, be sure raised
rib on battery pack aligns with groove in drill's battery
port and latches snap in place properly. Improper
assembly of battery pack can cause damage to internal
components.
BATTERY
PORT
BATTERY
PACK
LATCHES
DEPRESS LATCHES
TO RELEASE
BATTERY PACK
OPERATION
5
10
MODEL HP722
REVERSE
FORWARD