![background image](http://html1.mh-extra.com/html/ryobi/hp1442m/hp1442m_operators-manual_1504476008.webp)
Page 8
OPERATION
Fig. 2
WARNING:
If any parts are missing, do not operate tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
LED FUNCTION OF CHARGER
See Figure 2.
LED WILL BE LIGHTED TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
■
Red LED lighted = Fast Charging Mode
■
Green LED lighted = Fully Charged Battery Pack
■
Yellow and Green LED Lighted = Control Charge or
Defective Battery Pack.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to fully charge.
TO CHARGE
■
Charge battery pack only with the charger provided.
■
Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only.
■
Connect charger to power supply.
■
Place battery pack in charger.
See Figure 3. Align raised
rib on battery pack with groove in charger.
■
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
■
Normally, the yellow and green lights on the charger will
come on. This indicates charger is in control charge
mode and should switch to fast charge mode within 5
minutes. When charger is in fast charge mode the red
light will come on. If after a period of 15 minutes the
yellow and green lights remain on, remove the battery
pack, wait 1 minute and reinsert battery pack in charger.
If the yellow and green lights continue to remain on an
additional 15 minutes, the battery pack is damaged and
will not accept charge.
■
When your battery pack becomes fully charged, the red
light will turn off and the green light will turn on.
■
After normal usage, 1 hour of charge time is required to
be fully charged. A minimum charge time of 1 to 1-1/2
hours is required to recharge a completely discharged
tool.
■
The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
■
DO NOT place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
BATTERY
CHARGER
GREEN LIGHT "ON"
INDICATES FULLY
CHARGED
YELLOW AND GREEN LIGHTS "ON"
INDICATES CONTROL CHARGE OR
POSSIBLE FAULTY BATTERY
RED LIGHT "ON"
INDICATES FAST
CHARGING MODE
Fig. 3
BATTERY
PACK
BATTERY
CHARGER
IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERIES
When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger/charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charger/charging assembly to your nearest Ryobi
Authorized Service Center for electrical check.