APPLICATIONS
(Use only for the purposes listed below.)
Drilling wood, materials and resin boards.
Drilling concrete (impact drilling only).
Drill metal, steel, brass, aluminum sheets,
stainless steel & pipe.
NOISE BUILD-UP
Noise (sound pressure level) in the workplace
can exceed 85 dB (A). In this case, sound
insulation and hearing protection measures must
be taken by the operator.
SWITCH (Fig. 1)
This tool is started and stopped by pressing and
releasing the trigger switch (1).
The speed can be adjusted in the high gear
or in the low gear, by controlling the trigger
pressing force.
For continuous operation, press the lock button
(5) while pressing the trigger. Press again to
release the lock.
VARIABLE SPEED (Fig. 2)
Your drill has a variable speed control mechanism
designed for speed and torque control.
The speed and torque of the drill can be
increased by rotating the variable speed control
dial.
Turn the dial (4) to the “+” direction to increase
the speed and to the “-” direction to decrease
the speed.
NOTE: Use lower speeds for starting holes without
a centre punch, drilling metals or plastic, driving
screws and drilling ceramics or in applications
requiring a higher torque. Higher speeds are better
for drilling wood, wood compositions and for using
abrasive and polishing accessories.
CHANGING THE ROTATION DIRECTION (Fig. 3)
To change the rotation direction, stop the tool and
push the forward / reverse button (2).
When the forward button is pushed in, the bit
rotates clockwise when viewed from the handle
end of the tool.
When the reverse button is pushed in, the bit
rotates counterclockwise.
MOUNTING AND REMOVING THE BIT (Fig. 4a &4b)
The drill features a keyless chuck (3) and spindle
lock button (11) for greater convenience of use.
To insert a drill bit, press the spindle lock button
with one hand and use your other hand to rotate
the chuck anti-clockwise. Rotate it sufficently for
the chuck to open far enough to accept the bit
or accessory.
Fully insert the bit accessory into the chuck and
tighten securely by rotating the chuck clockwise
with one hand whilst holding the spindle lock
button pressed with the other hand.
Repeat 2nd point to remove the bit.
NOTE: Always be sure the spindle lock button is
released and the spindle lock is disengaged before
turning the drill ON.
Page 4
FEATURES
Fig. 1
1
5
2
Fig. 3
Fig. 2
4
