Ryobi EBS800, Instruction Manual

Page: 6 / 20

■ Use the dust collector or connect the dust port to a
vacuum device to reduce risks associated with dust
particles.
■ All persons within the work area or nearby should wear
dust masks which offer appropriate protection.
■ Always wear safety goggles or safety glasses with side
shields when operating products.
■ Use the sanding frame and the fence attachments when
using the product in the inverted mode of operation.
Use of the attachments helps to control the position of
the workpiece and prevents accidental contact with the
moving belt and rollers.
■ When used in the inverted mode, the product must be
adequately secured to a suitable work bench using the
accessory clamps provided. See graphic instructions
later in this manual.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
WARNING
When servicing, use only original manufacturer’s
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Electric tools used on fiberglass material, wallboard, spackling
compounds or plaster are subject to accelerated wear and
possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
commutators, etc. We do not recommend using the product
for extended periods of time on these types of materials.
After each use, remove the belt and dust collector if fitted.
Clean the dust collector as shown in the illustrations in this
manual. Clean the product thoroughly with a brush, dry cloth
and vacuum cleaner.
WARNING
Do not use compressed air to blow dust from the product
to prevent serious eye injury.
WARNING
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer
or its service agent. Contact the authorised service
centre.
For greater safety and reliability, all repairs should be
performed by an authorised RYOBI service centre.
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOL
Safety Alert
V
Volts
Hz Hertz
Alternating current
W
Watts
n
o
No-load speed
min־¹ Revolutions or reciprocations per minute
CE Conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Class II tool, double insulated
Please read the instructions carefully before
starting the product.
Wear ear protection
4