5
Fig. 6
A. SHAFT ADJUSTMENT COLLAR
B. LOWER PORTION OF SHAFT ADJUSTMENT
COLLAR
C. TO LOCK COLLAR
Fig. 7
A. BATTERY PACK
B. LATCHES
Fig. 8
A. TRIGGER LOCK BUTTON
B. TRIGGER
Fig. 11
A. CUT OFF BLADE
Fig. 14
A. BUMP KNOB
B. SLOT ON SPOOL
C. SPOOL CAP
D. TABS
E. SPOOL
F. SPRING
G. SPOOL HOUSING SLOT
H. OPENING IN SPOOL HOUSING
I. SPOOL HOUSING
ASSEMBLY
INSTALLING THE GRASS SHIELD
n
Remove both screws on the motor housing. Orient grass
shield on the motor housing and twist to lock in place as
shown.
n
Re-install screws to secure grass shield in place.
See
Figure 2.
ATTACHING THE FRONT HANDLE
n
Press the front handle onto the shaft.
See Figure 3.
n
Move it to a position on the shaft suitable for the user.
n
Secure it with the bolt, wing knob and washers in the
sequence as shown.
n
Tighten the bolt to ensure the handle is fixed firmly.
ADJUSTING THE SHAFT
n
Rotate the lower portion of the shaft adjustment collar to
the “Unlock” position.
See Figure 4
.
n
Lower shaft should now be free to slide down from inside
the upper shaft. Make sure the shaft is pulled out to the
desired position.
See Figure 5
.
ENGLISH (Original Instructions)
n
Rotate shaft adjustment collar to the “Lock” position and
tighten securely .
See Figure 6
.
WARNING:
If any parts are missing, do not operate unit until
the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
OPERATION
INSTALLING THE BATTERY PACK
n
Place the battery pack in the string trimmer. Align
raised rib on battery pack with groove in string trimmer.
See Figure 7.
n
Make sure the latches on the battery pack snap in place
and that battery pack is secured in string trimmer before
beginning operation.
REMOVING THE BATTERY PACK
n
Locate latches of battery pack and depress both sides
to release the battery pack from the string trimmer.
See
Figure 7.
n
Remove battery pack from the string trimmer.
CAUTION:
When placing battery pack in your string trimmer,
be sure raised rib on battery pack aligns with
groove in string trimmer and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components.
REMOVING ADDITIONAL SPOOL FROM SPOOL HOLDER
n
Turn the spool in the spool holder (Fig. 1 - B)
counterclockwise and pull the additional spool out of the
holder
ADDING ADDITIONAL SPOOL TO SPOOL HOLDER
n
Push the spool into the spool holder (Fig. 1 - B) and turn
clockwise until the spool clicks into a safe position
STARTING THE STRING TRIMMER
n
Press and hold the trigger lock button.
See Figure 8.
This
makes the trigger operational.
n
Release the trigger lock button and continue to squeeze
the trigger for extended operation.
STOPPING THE STRING TRIMMER
n
Release the trigger to stop the string trimmer.
n
Upon release of the trigger, the trigger lock button will be
automatically reset to the lock position.