![background image](http://html1.mh-extra.com/html/ryobi/cld-1880k/cld-1880k_owners-operating-manual_1504374006.webp)
5
IMPORTANT INFORMATION FOR RECHARGING HOT
BATTERIES
CHARGING BATTERY PACK (Fig. 7, 8)
The battery pack for the tool has been shipped in a low charge
condition to prevent possible problems. Therefore, you should
charge it prior to use.
When using your tool continuously, the batteries in your battery
pack will become hot. You should let a hot battery pack cool down
for approximately 30 minutes before attempting to recharge.
1. While pressing the battery pack clip (7) gently slide out the battery
pack from driver drill. (Fig. 7)
2. Plug the battery charging adaptor (10) into a power outlet.
3. Plug the charger jack (11) into the charging socket on the battery
pack firmly. The LED charging status lamp turns to RED to
indicate it charging. (Fig. 8)
4. Once the charging completed, the LED charging status lamp
turns to GREEN. Remove the charging adaptor from the battery
pack, and then plug off the charging adaptor.
NEVER COVER THE AIR VENTS SINCE THEY MUST ALWAYS
BE OPEN FOR PROPER MOTOR COOLING.
DRILLING IN WOOD
To prevent splintering around the drilled hole on the reverse side
of the work piece, place scrap lumber beneath the material to be
drilled.
DRILLING IN METAL
Metals such as steel sheets, brass and aluminum sheets, stainless
steel and pipe may also be drilled. Mark the point to be drilled with
a nail or punch.
DRIVING SCREW
Match the bit and screw size to prevent damage to the screw head.
For removing screws, push the reversing switch to the left position.
After use, check the tool to make sure that it is in top condition.It
is recommended that you take this tool to a RYOBI Authorized
Service Center for a thorough cleaning and lubrication at least
once a year.
DO NOT MAKE ANY ADJUSTMENTS WHILE THE MOTOR IS
IN MOTION.
ALWAYS REMOVE THE BATTERY FROM THE TOOL BEFORE
CHANGING REMOVABLE OR EXPENDABLE PARTS
(BIT...ETC.), LUBRICATING OR WORKING ON THE UNIT.
WARNING!
To ensure safety and reliability, all repairs should be performed by
an
AUTHORIZED SERVICE CENTER or other QUALIFIED
SERVICE ORGANIZATION.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
NOTE:
Batteries will not reach full charge the first time they are
charged. Allow several cycles for them to fully charge.
• Charge battery pack only with the charger provided.
• D
o not place charger in an area of extreme heat or cold. It will
work best at temperatures above 10°C and below 38°C.
• M
ake sure power supply is normal house voltage, 230 volts,
50Hz, AC only.
CAUTION!
OPERATING
MAINTENANCE
Summary of Contents for CLD-1880K
