3
FEATURES
Figure 1
A. Keyless chuck
B. Trigger
C.
Direction of rotation selector (Forward/Reverse)
D. Screwdriver bits
E. Battery pack
F.
Depth gauge Rod
G. Auxiliary handle
Figure 2
A. Battery pack
B. Latches
C.
Depress latches to release battery pack
Figure 3
A. Auxilary Handle
B. To Tighten
C. To Loosen
Figure 4
A. Drill bit
B.
Depth Gauge Rod
C. Drilling Depth
Figure 5
A.
To Decrease torque
B.
To Increase torque
C.
Torque adjusting Ring
D. Drill mode
E. Impact mode
Figure 6
A.
Forward / Reverse selector
B. Reverse
C. Forward
D. Switch
Figure 7
A. Unlock (release)
B. Chuck
C. Drill bit
D. Chuck jaws
E. Lock (tighten)
Figure 9
A. Battery Charger
B. Green Light
C. Red
D. Yellow and green
Light
OPERATION
LED FUNCTION OF CHARGER
See Figure 9.
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
Red LED on = Fast charging mode.
Green LED on = Fully charged battery pack.
No LED on = Defective charge or battery pack.
CHARGING YOUR BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
Note:
Batteries will not reach full charge the first time
they are charged. Allow several cycles for them to
fully charge.
TO CHARGE
Charge battery pack only with the charger provided.
Make sure power supply is normal house voltage,
240 volts, 50 Hz, AC only.
Connect charger to power supply.
Place battery pack in charger. Align raised rib on
battery pack with groove in charger.
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
When your battery pack becomes fully charged,
the red light will turn off and the green light will turn on.
After normal usage, 1 hour of charge time is required
to be fully charged.
When yellow and green lights "ON" indicates control
charge or possible faulty battery.
A minimum charge time of 1 to
1-1/2 hours is required to recharge a completely
discharged tool.
DO NOT place charger in an area of extreme heat or
cold. It will work best at temperatures above 10ºC
and below 38ºC.
IMPORTANT INFORMATION FOR RECHARGING HOT
BATTERIES
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
TO INSTALL BATTERY PACK
Lock switch trigger on your drill by placing the
direction of rotation selector in centre position.
See Figure 6.
