5
SPECIFICATIONS
Model CHI1802P
Voltage 18
V
Chuck (mm)
2-13
Switch Variable
speed
No load speed (drill mode):
- Lo speed
0 - 400 min-1
- Hi speed
0 - 1400 min-1
No load speed (impact mode):
- Lo speed
0 - 5200 bpm
- Hi speed
0 - 18200 bpm
Max. Torque (Nm)
34
Weight - incl. battery pack (KG) 2.20
Charger
260010038
FEATURES
1. Keyless chuck
2. Switch trigger
3. Direction of rotation selector (Forward/Reverse)
4. Screwdriver bits
5 . Battery pack
6. Latches
7.
Depress Latched to Release Battery Pack
8. Torque adjusting Ring
9. To
Decrease
Torque
10 To
Increase
Torque
11. Impact
Mode
12. Drill
Mode
13. Reverse
14. Forward
15. Unlock
(Release)
16. Lock
(Tighen)
17. High
Speed
18. Low
Speed
19. Battery
Charger
20. LED
Indicator
21. Battery
Charger
22. Green
Light
23. Red
Light
24. Yellow
Light
OPERATION
CHARGING YOUR BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it prior to use.
Note:
Batteries will not reach full charge the fi rst time
they are charged. Allow several cycles for them to fully
charge.
CHARGER: 260010044
See Figure 7.
n
Charge battery pack only with the charger provided.
n
Make sure power supply is normal house voltage,
240 volts, 50 Hz, AC only
.
n
Connect charger to power supply.
n
Make sure charger plug and input jack are properly
connected.
n
Place battery pack in charger. Align raised rib on
battery pack with groove in charger.
n
Press down on battery pack to be sure contacts
on battery pack engage properly with contacts in
charger. When properly connected, red light will turn
on.
n
The LED indicator, which is located on the charging
stand, will light up when charger is properly
connected to power supply. This light indicates your
tool is charging and will remain on until charger is
disconnected from power supply.
n
After normal usage, 3-5 hours of charge time are
required to be fully charged. A minimum charge
time of 5 hours is required to recharge a completely
discharged tool.
n
DO NOT place charger in an area of extreme heat
or cold. It will work best at temperatures above 10°C
and below 38°C
IMPORTANT INFORMATION FOR RECHARGING HOT
BATTERIES
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
CHARGER: 260010038
See Figure 8.
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
n
Red LED on = Fast charging mode.
n
Green LED on = Fully charged and in maintenance
charge mode.
960931156-01.indd A5
960931156-01.indd A5
8/15/02 2:00:28 PM
8/15/02 2:00:28 PM
