3
OPERATION
Fig. 1
Fig. 2
Fig. 3
BATTERY PACK
(NOT INCLUDED)
GROOVES
TO REMOVE: DEPRESS
LATCH TO RELEASE
BATTERY PACK
TO
LOWER
SWITCH
TRIGGER
TO RAISE
HANGER
SCREW
RUBBER
CUSHION
PULL LENS COVER
FORWARD TO REMOVE
LENS COVER
FLUORESCENT TUBE
(9W U-TYPE TUBE)
FLUORESCENT TUBE
SOCKET AREA
CAUTION
When placing battery pack in your fluorescent light, be
sure raised ribs on battery pack aligns with groove inside
light handle and latches snap in place properly. Improper
assembly of battery pack can cause damage to internal
components.
SWITCH
See Figure 2.
To turn your light on and off, depress switch trigger.
HANGING / STORAGE FEATURE
See Figure 2.
On top of the housing is a hook in which you can use to
hang the light up. This is a good feature for storing light
when not in use and also to keep light out of the reach of
children. To use, simply lift up on hook.
TUBE REPLACEMENT
See Figure 3.
WARNING
During the change of lamp the battery has to be not
contacted with the luminaire.
Use only with above listed fluorescent tube, other type of
fluorescent tubes will result in a risk of electric shock.
TO REPLACE FLUORESCENT TUBE
n
Remove battery pack from fluorescent light.
n
Remove screw to release lens cover. Remove lens cover
by pulling forward and lifting from the housing.
n
To remove old fluorescent tube from spring, gently
grasp the lower edge of the rubber cushion and sides of
bulb. Carefully work tube in a side-to-side motion while
easing tube forward and up until tube is free from the
spring. Do not pull fluorescent tube straight out from its
center, as this increases chance of breakage. Remove
rubber cushion from old fluorescent tube and place on
top of new tube, rounded edge facing outward.
n
Insert new fluorescent tube in spring by aligning prongs
on tube with holes in tube socket area. Gently push
down on base of new tube until fully engaged. Do not
force tube into place.
n
Replace lens cover by sliding lower edge into housing.
Align screw holes at top. With a screwdriver, tighten
screw.
n
Replace battery pack.
WARNING
Do not attempt to disassemble the battery pack. Fire or
injury may result.
