Page 1
1
OPERATION
REMOVING BITS
See Figure 6.
■
Place the direction of rotation selector in center position.
See Figure 3. This will turn off the power to your drill.
■
Loosen the chuck jaws from drill bit
.
■
To loosen: grasp and hold the collar of the chuck with
one hand, while rotating chuck body with your other hand.
Note:
Rotate chuck body in the direction of the arrow
marked
RELEASE
to loosen chuck jaws.
■
DO NOT
use a wrench to tighten or loosen the chuck jaws.
■
Remove drill bit from chuck jaws.
SCREWDRIVING
TORQUE ADJUSTMENT
(Driving power of your drill-driver)
When using your drill-driver for various driving aplications, it
becomes necessary to increase or decrease the torque in
order to help prevent the possibility of damaging screw
heads, threads, workpiece, etc. In general, torque should
correspond to the intensity of the screw diameter. If the
torque is too high or the screws too small, the screws may be
damaged or broken.
The torque is adjusted by rotating the torque adjustment ring.
See Figure 8. The torque is greater when the torque adjust-
ment ring is set on a higher setting. The torque is less when
the torque adjustment ring is set on a lower setting.
The proper setting depends on the type of material and the
size of screw you are using.
TO ADJUST TORQUE
■
Identify the twenty four torque indicator settings located
on the front of your drill.
See Figure 8.
■
Rotate adjustment ring to the desired setting.
• 1 - 4
For driving small screws.
• 5 - 8
For driving screws into soft material.
• 9 - 12
For driving screws into soft and hard
materials.
• 13 - 16
For driving screws in hard wood.
• 17 - 20
For driving large screws.
•
•
21 -
For heavy drilling.
For impact drilling
BIT STORAGE
See Figure 9a.
See Figure 9b.
When not in use, bits provided with your drill can be placed
in the storage area located on the top of your drill as shown
in figure 9a.
IMPACT ACTION
The drilling action on models CID1442P and CID1802P can
be altered to hammer action mode for drill masonry by turning
the mode dial located at the front of the torque
control mechanism.
Simply turning the dial to align the small hammer with the
arrow shifts the dri
l
l into hammer action mode. For best results
please use
H
igh Gear and specialised Masonry drill bits.
