![background image](http://html1.mh-extra.com/html/ryobi/cdi-1443-cdi-1803/cdi-1443-cdi-1803_user-manual_1504364014.webp)
OPERATION
■
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
■
When your battery pack becomes fully charged,
the red light will turn off and the green light will turn on.
■
After normal usage, 1 hour of charge time is required
to be fully charged. A minimum charge time of 1 to
1-1/2 hours is required to recharge a completely
discharged tool.
■
DO NOT place charger in an area of extreme heat or
cold. It will work best at temperatures above 10°C
and below 38°C.
IMPORTANT INFORMATION FOR RECHARGING HOT
BATTERIES
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
TO INSTALL BATTERY PACK
■
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 6.
OPERATION
■
Place battery pack in your drill. Align raised rib on
battery pack with groove inside drill.
See Figure 2.
■
Make sure the latches on battery pack snap in place
and battery pack is secured in drill before beginning
operation.
TO REMOVE BATTERY PACK
■
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 6.
■
Locate latches of battery pack and depress to release
battery pack from your drill.
See Figure 2.
■
Remove battery pack from your drill.
ADJUSTING THE AUXILIARY HANDLE
See Figure 3.
Follow these steps to adjust the auxiliary handle.
■
Loosen the auxiliary handle by turning the knob
counterclockwise.
■
Rotate the auxiliary handle to the desired location.
■
Tighten the auxiliary handle securely by turning the
knob clockwise.
ADJUSTING THE DEPTH GAUGE ROD
See Figure 4.
Follow these steps to adjust the depth gauge rod.
■
Lock the trigger switch by placing the rotation selector
in the center position.
■
Loosen the auxiliary handle by turning the knob
counterclockwise.
■
Adjust the depth gauge rod so that the drill bit
extends beyond the end of the rod to the required
drilling depth.
■
Tighten the auxiliary handle by turning the knob
clockwise.
ADJUSTING THE TORQUE
See Figure 5.
The tool is equipped with an adjustable torque clutch for
driving different types of screws into different materials.
Adjust the torque as necessary.
We recommend that you use carbide-tipped bits and
select impact mode when drilling in hard material such as
brick, tile, concrete, etc.
CAUTION
The impact drill is not designed for reverse
hammering. Failure to obey this caution may
result in property damage.
SWITCH
See Figure 6.
■
To turn your drill ON, depress the switch trigger.
■
To turn it OFF, release the switch trigger.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
SWITCH LOCK
See Figure 6.
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch trigger,
place the direction of rotation selector (Forward/Reverse
Selector) in center position.
Note: When selector is in center position, switch trigger
is locked.
10
GB
F
D
E
English
I
P
NL
S
DK
N
FIN
GR
H
CZ
RUS
RO
PL
960299055-03(A) CDI 1443-1803.qxd 12/22/2003 8:08 AM Page 10