4
WARNING:
The table saw should never be connected to a power
supply when you are assembling parts. Disconnect-
ing the saw will prevent accidental starting that could
cause serious personal injury.
ASSEMBLING THE T-NUT
See Figure 3.
Slide the special 5/16 in. T-nut into the top channel of the
miter fence as shown.
ASSEMBLING THE POST
See Figure 3.
■
Place the spacer provided on the threaded end of
the post.
■
Thread the post through the spacer into the 5/16 in.
T-nut in the top channel of the miter fence.
■
Tighten the post securely with an adjustable wrench.
NOTE: The adjustable wrench will fit the flats on top
of the post.
ASSEMBLING THE MITER CLAMP
See Figure 2.
NOTE: When the miter clamp is correctly positioned
on the post, the clamp is spring loaded. Spring
loading holds the miter clamp out of the way while
workpieces are placed or removed.
■
Loosen the knob bolt threaded into the back of the
miter clamp. DO NOT TIGHTEN THE BOLT UNTIL
THE WORKPIECE IS IN THE DESIRED POSITION
AND YOU ARE READY TO SECURE THE MITER
CLAMPER.
■
Orient the miter clamp as shown.
■
Slide and turn the miter clamp on the post to acti-
vate the spring. The miter clamp is now spring loaded
against the post and will remain in position when
you release it.
Fig. 2
ASSEMBLY
KNOB BOLT
MITER CLAMP
POST
TO
TIGHTEN
TO
LOOSEN
TO
TIGHTEN
SPACER
5/16 in.
T-NUT
TO
LOOSEN
MITER FENCE
Summary of Contents for 4710300
Page 6: ...6 NOTES ...
