4
TOOLS NEEDED
Fig. 3
INSTALLING THE MITER SLOT TABLE
See Figure 3.
■
Turn the ON/OFF switch to the OFF position.
■
Unplug the saw from the switched on-board outlet.
■
Disconnect the saw from the power supply.
■
Remove the sliding miter table and accessory table
from the saw.
■
Place the miter slot table onto the saw as shown in
Figure 3.
WARNING:
The table saw should never be connected to a power
supply while you are assembling parts. Disconnect-
ing the table saw will prevent accidental starting that
could cause serious personal injury.
ASSEMBLY
7/16 in. NUT DRIVER
Fig. 2
3/16 in. HEX KEY
1/4-20 x 1 in.
HEX CAP SCREW
WASHER
1/4-20 NUT
SHIMS
MITER
SLOT TABLE
