![background image](http://html1.mh-extra.com/html/ryobi/150r/150r_operators-manual_1506871007.webp)
ASSEMBLY INSTRUCTIONS
7
This unit is completely assembled. However,
some adjustments may be required to provide
safe and easy use for the operator.
It is suggested that you mount the charging unit
per instructions and allow the unit to charge for
at least 36 hours prior to first use.
MOUNTING THE CHARGING STATION
Since this unit may stay on the charging station
continuously without overcharging, it is
suggested that the charging station be in a
place where the unit is intended to be stored.
This should be a place that is cool, dry and well
ventilated, where the unit can be locked-up and
out of the reach of children.
Your unit should be charged and stored in a
location where the temperature is more than
50˚F (10˚C) but less than 100˚F (38˚C).
1. Locate a place for the charging station near
a wall outlet and high enough to keep the
unit off the floor.
2. Locate the wall stud and mount the charging
station to the wall using the three (3) screws
provided (Fig 1). Make sure that the screws
enter the wall stud to provide a secure
mount.
CAUTION:
To prevent injury or
damage to the unit, the charging
station must be mounted securely
to the wall.
3. Plug the charger into the wall outlet and
wrap any excess wire onto the cord wrap
on the charging station (Fig. 1).
Wall
Outlet
Charging
Station
Screw
Wall Stud
Cord
Wrap
Charger
INSTALLING AND ADJUSTING THE
D-HANDLE
1. Push the D-handle down onto the shaft
housing so that the handle slants to the
powerhead (Fig. 2). The squared bolt hole in
the handle is to the right.
2. Insert the shoulder bolt and washer into the
squared hole in the handle. Screw the wing
nut onto the bolt.
3. Rotate the D-handle to place the grip above
the top of the shaft housing.
4. While holding the unit in the operating
position (Fig. 3), position the D-handle to the
location that provides you the best grip, and
tighten the wing nut (Fig. 4).
Bolt
Grip
Wing
Nut
Washer
Fig. 4
Fig. 2
Fig. 1
Fig. 3