RYNO WORX RY10MA, Owner'S Manual

Page: 10 / 27

Slide the rear wheels on the axles.
Include washers on both sides of each wheel.
Secure the wheels with a cotter pin in each axle.
washer and split lock washer on each bolt.
front wall with 4 x 30 mm M12 bolts. Include a
Fasten the front caster subassembly on the melter
Cut the zip tie and
lower the shoe to
the ground.

Assembly Instructions
Part 3
– Assemble Melter According to the Illustrations and Instructions
With all the parts laid out on a flat working surface, follow the assembly illustrations below to complete the
assembly of the melter. A socket set, rubber mallet, needle nose pliers and open ended wrench set are
required in order to complete the assembly.
9