6/10
X. CONFIGURATION AND FUNCTION OF MENU
1.Setting the mode
a. Press Mode button,and the screen will display:Body...°C
b. Press again and the screen will display:Surface Temp...°C
c. Press again and the screen will display:Room...°C
Note: The RC004T default is set to BODY mode.
2.
Press the °C/°F button to transfer between Celsius and Fahrenheit
3. Press Mem (Memoy) button, which will then display the last
temperature,and allows for a view of the last 32 measurements taken.
4.The Language button to display a choice of three languages, as well as
an “off” setting, which will silence the talking feature of the unit.
Important!
The surface body temperature differs from the internal body temperature.
To obtain the internal temperature, always use the “BODY” mode.
Please make sure to select the BODY mode for an internal temperature
reading and the SURFACE TEMP mode for an external area reading.
IX.INSTRUCTIONS
1. Install battery.
2. For the first usage or when inserting new batteries, wait from
10-15 minutes for the warm-up of the unit. This will allow
the unit to become acclimated to the temperature of
the room.
3. Aim towards the desired location, keeping the unit at a
distance of 3-5 cm (1.2-2 inches) from the dog, and press the
Scan Button. Results will be displayed and/or spoken in one second.
Rycom recommends that the dog’s temperature readings should be taken primarily
the inside of the ear (simply point the unit at the inside of the ear). Depending on the
dog, you may choose to use the perenial area, belly, or upper gum (for areas other than
the ear, recalibration of the unit may be required – see Key Functions below).
5.Recalibration of device via the F4 MENU
** Please note: Each breed of dog will have an optimum calibration setting in
order to obtain the most accurate temperatue reading.
