ryan 544863B, Technical Manual

Page: 5 / 29

3
4193
1
2
3
Figure 5. Clutch Cable Attachment
1. Clutch Control Handle
2. Clutch Cable Eye
3. Spring
8. Adjust the position of the cable clamp (See Figure 4)
so that when the clutch handle is pulled back and the
idler engages the belt, the clutch spring (See
Figure 5) is extended 3/8
″
(10mm). Release the
clutch and make sure the belt disengages com-
pletely.
9. Unwrap throttle cable from engine. Hook cable end
into throttle lever on right side of clutch control han-
dle. Install cable clamp as shown in Figure 6, but DO
NOT tighten clamp.
5069
1
2
3
Figure 6. Throttle Cable Attachment
1. Throttle Cable
2. Cable Clamp
3. Throttle Lever
BRIGGS AND STRATTON ENGINE
10. Make sure throttle friction wing nut is loosened to
allow free movement of throttle control.
Remote adjustment throttle control.
Loosen casing clamp screw on control plate. Pull
clutch handle all the way rearward. Move casing and
wire to end of travel to move throttle control to FAST
position. Tighten casing clamp screw. See Figure 7.
THROTTLE
STOP
SCREW
THROTTLE
FRICTION
NUT
WIRE
CASING
CASING
CLAMP
SCREW
THROTTLE
CONTROL
Figure 7. Remote Throttle Control
HONDA ENGINE
Remote adjustment throttle control.
Make sure throttle lever friction nut is loosened
enough to allow free movement of throttle lever. Pull
clutch handle all the way rearward and push the
throttle cable forward until the throttle lever on the
engine is fully advanced. Tighten cable clamp
securely.
THROTTLE
LEVER
FRICTION NUT
THROTTLE
LEVER
THROTTLE
CABLE
THROTTLE
CABLE
CLAMP
Figure 8. Honda Remote Throttle Control
11. Secure all cables to the center support of the handle
using the two tie straps provided.
12. Attach height adjustment tubes to height adjustment
links. A nylon bearing is taped into the lower end of
each tube. Secure both sides with shoulder bolts,
lockwashers and nuts. See Figure 9.