11
OPERATING YOUR FILTER
NOTE
Your filter cannot be run if the water is not at the proper level in the
pool. Running the filter without water can cause serious damage to
your pump and filter.
NOTE
NEVER move selector handle while pump is on. Pump MUST be
switched off to change the position of the valve. Failure to comply
will cause damage to your valve and is not covered by WARRANTY.
•
Prime filter prior to starting up filter system. DO NOT turn motor on until system has been primed,
you can damage your pump.
•
Make sure water in pool is up to middle of skimmer(s) and that there is nothing blocking water
flow from return(s) and skimmer(s) (i.e. plug, plate).
•
Push down selector handle on valve and turn to notch labeled BACKWASH. Let go of handle
and the valve is now in backwash position. Make sure backwash hose (sold separately) is
attached to the waste port so water will not spray all over you once pump is started.
•
Remove lid of strainer basket on pump (if applicable) and fill with water. Skimmer and return lines
should be filled with water as well (when water level is in proper place in pool this will happen
naturally).
•
Place cover back on basket and plug in/switch on pump. When pump starts up, water will come
out through the backwash hose. If the pump is properly primed, the water in the strainer basket
will fill completely and air pocket will be eliminated.
•
Repeat above until all air is purged from the system then turn off the pump. If this does not get
air out of system, double check all connections to make sure they are properly tightened and try
again.
•
To use filter, with pump OFF, push down selector handle on valve and turn to notch labeled FILTER.
•
Connect pump to power to start filter operation.
•
Note pressure gauge reading at this time.
•
When pressure through return fades and pressure gauge reads 5 psi above starting pressure,
you will need to backwash the filter system to remove debris.
•
Turn pump off before moving selector to BACKWASH position. Once in backwash, turn pump
back on.
•
Water will come out through the waste port, so position backwash hose where you would like
water to run out.
•
NEVER backwash for longer than ONE MINUTE at a time! Backwashing longer than one minute
will cause sandblasting of internal components and can lead to damage of standpipe and/or
hub and VOIDS WARRANTY.
•
Turn pump off and move selector to RINSE position. Rinse will allow water to flow through to
clear out the lines and prevent a puff of sand or debris back into the pool after backwashing.
•
Rinse for approximately 15 seconds and turn off pump again. Move selector back to filter and turn
pump back on. You are now filtering water.
