RWD WJH1355-2, Operation Instructions

Page: 2 / 3

6.Connect the other end of hose (built in
cushion
)to the screw thread of G12” inlet.
7. Place the main body of eye wash on the tray
8. Connect the inlet pipes, inspect whether the connects is firm, whether have leakage.
9.Test: draw out the eye wash, press down the Push button and push forward, then open
the switch, inspect whether sprayer head is smooth, whether have impurity is not clear,
the water beam is suitable for washing eyes. Test finished, pullback the push button
and loosen, then close the switch.
※
Instructions for use
：
When used, the extract eyewash body from the tray, press down the push button with the
thumb while pushing forward, switching valve to be opened and lock the water, that line
flushing, flushing is completed, pullback the button and release that switch off, and then
place the main body of eye wash on the tray .
※
Troubleshooting suggestions:
No. Fault CAUSE Remedy
1 Small water flow of
nozzles
Inlet has stolen goods
nozzle hole are blocked
Low water pressure
Unscrew the nozzle
cleaning booty
Increase water
pressure
2 Hose connections leaking Cushion of connecting
nut damaged
Replace the
cushion
※
Notices
：
1 If the pressure is less than 0.15Mpa, the water may cause adverse effects, above
0.5Mpa, will lead to the closure lax.
2
Should not be forced to reverse when extracting the main body of eye wash, bend the
hose should go with the flow.