23.
Move the feet to the desired locations, I suggest the front feet should rest flush up against the back of the
front panel, and the back feet should sit on or just inside the back panel as shown above and below. After
the screws are tightened peal off the rubber feet from the backing and install them into the recess in each
foot. Turn the amp right side up and press firmly down on the amp for a few seconds to make sure the
feet are properly seated.
24.
Install the set screw in the volume knob, there are two knobs included in the kit allowing you to choose
the look or feel you prefer. With the screw still loose install the knob on the shaft of the pot, the knob
should not be pressed tight up against the face of the amp or the knob will bind when turning. Instead
leave a small gap between the two allowing smooth operation.
The amplifier is now complete.
Give yourself a pat on the back and prepare to test your creation.
25.
Insert the power plug into the connector on the back of the amp. Plug the power supply into a suitable
wall socket. Turn the volume knob clockwise to turn on the amp, the green LED should illuminate.
