RVS PD-062710, Instruction Manual, Page: 8 / 26

8 © Rear View Safety
REQUIRED TOOLS & SUPPLIES
- Tall ladder and step ladder.
- Cordless drill and 1/4” accessories.
- Various drill bits.
- 3/4”, 7/8” and 1” hole saws.
- Various hand tools: wrenches, sockets, screwdrivers, etc.
- Wire crimper, wire stripper.
- Measuring tape.
- Wire fish tool.
- Razor knives.
- Brush on primer for cable and sensor holes in sheet metal.
- White touch up paint.
- Long and short zip ties.
- Silicone.
WIRING REQUIREMENTS – ALL VEHICLES
Required power connections:
•
Accessory/Ignition
•
Chassis Ground
•
Reverse
•
Left front turn signal
•
Right front turn signal
Note: You must use the front turn signal wires unless the rear turn signal and stop
lights are independent of each other. The monitor view will not work properly
when pressing the brake pedal if connected to the stop lights.
NOTE: Wire will have to run from the front to the back of the truck.
Run the Rear Wire of ECU from the REVERSE IGNITION to the rear of the chassis.