5
5
5
5
OPERATING
OPERATING
OPERATING
OPERATING
INSTRUCTION
INSTRUCTION
INSTRUCTION
INSTRUCTION
S
S
S
S
Fig1
Fig1
Fig1
Fig1
The refrigerator can be run on either 240 V or LP gas, or even 12VDC for some models. Changing
between these modes of operation is carried out by means of control buttons positioned as shown in
fig. 1.
The refrigerator temperature is controlled by a thermostat (A). Please note that the thermostat has no
"off" position.
The refrigerator is fitted with a safety device which automatically shuts off the supply of gas if the
flame goes out. The safety device can be opened manually by depressing knob (B).
In the flame indicator (C), you can see a blue light when the flame is alight.
The piezoelectric igniter discharges sparks over the burner when the button (D) is depressed.
The power switch (E) can be set at either
III
I
(= 240 V), or
0
0
0
0
(=Electricity power is off , while LP gas or
12VDC needs to be connected.). The Neon lamp inside will light when the electric power is on.
LP
LP
LP
LP
Gas
Gas
Gas
Gas
operation
operation
operation
operation
After initial installation, servicing, or changing gas cylinders etc., the gas pipes may contain some air
which should be allowed to escape by briefly turning on the refrigerator. This will ensure that the
flame lights immediately.
1. Make sure that all valves between the gas container and the refrigerator are open.
2. Turn off the power switch (E).
3. Depress the safety device control (B) and hold it down while depressing the piezoelectric igniter
button (D) repeatedly.
4. Check the flame indicator (C) to see whether the flame is alight.
5. Keep the safety device control depressed for a further 10-15 seconds.
6. Release the safety device control and again check to see that the flame is alight.
To terminate gas operation, turn off the gas valve from the gas container.
240
240
240
240
V
V
V
V
AC
AC
AC
AC
Operation
Operation
Operation
Operation
Make sure that the gas valve is turned off.
Plug the power cord to the power socket.
Turn on the power switch, see its neon lamp is on.
DC
DC
DC
DC
12V
12V
12V
12V
Operation
Operation
Operation
Operation
If 240 VAC or LP gas is not available, the refrigerator can work with DC12V (3-Way models only).
You can connect the 12VDC power to the terminal block which is available in the rear bottom part of
the refrigerator.
DC operation is not as efficient as LP Gas or AC operation. DC electric should not be used to initially
cool the refrigerator. Only use DC when the other modes are unavailable (for example; while in
transit).
REGULATING
REGULATING
REGULATING
REGULATING
THE
THE
THE
THE
TEMPERATURE
TEMPERATURE
TEMPERATURE
TEMPERATURE
The position number refers to fig. 1.
It will take several hours for the refrigerator to reach normal operating temperature.
The temperature of the main compartment of the refrigerator is controlled by a thermostat. The
thermostat knob (A) should be set at 1-4. If a lower (colder) temperature is desired, set the thermostat
to a higher figure.
A: Thermostat knob
B: Safety valve gas purge button
C: Flame indicator
D: Piezo ignitor
E: Main power switch
